#ifndef _PRST_CONFIG_H_
#define _PRST_CONFIG_H_

#include "nrf_gpio.h"

// Some configurations are version-specific. Uncomment the line corresponding
// the the version you're programming. The version can be found on the
// b-parasite board.
// #define PRST_VERSION_1_0_X
#define PRST_VERSION_1_1_X

// Built-in LED.
#define PRST_LED_PIN NRF_GPIO_PIN_MAP(0, 28)

// Deep sleep.
#define PRST_DEEP_SLEEP_IN_SECONDS 2

// Analog to digital converter (ADC).
// Prints out ADC debug info, such as the values read for battery and soil
// moisture.
#define PRST_ADC_BATT_DEBUG 0
#define PRST_ADC_SOIL_DEBUG 0

// BLE.
// Prints out BLE debug info, such as the final encoded advertisement packet.
#define PRST_BLE_DEBUG 0
#define PRST_BLE_PROTOCOL_VERSION 1
// We're using a random static MAC address, which has the following constraints:
// 1. Two most significant bits are set to 1;
// 2. The remaining bits should not _all_ be set to 0;
// 2. The remaining bits should not _all_ be set to 1;
#define PRST_BLE_MAC_ADDR "f0:ca:f0:ca:01:01"
#define PRST_BLE_ADV_NAME "prst"
// Total time spend advertising.
#define PRST_BLE_ADV_TIME_IN_MS 1000
// Interval between advertising packets.
// From the specs, this value has to be greater or equal 20ms.
#define PRST_BLE_ADV_INTERVAL_IN_MS 30
// Possible values are ..., -8, -4, 0, 4, 8.
#define PRST_BLE_ADV_TX_POWER 8

// PWM.
#define PRST_PWM_PIN NRF_GPIO_PIN_MAP(0, 5)

#ifdef NRF52833_XXAA
#define PRST_FAST_DISCH_PIN NRF_GPIO_PIN_MAP(0, 25)
#else
#define PRST_FAST_DISCH_PIN NRF_GPIO_PIN_MAP(1, 10)
#endif

// SHT3C temp/humidity sensor.
#define PRST_SHT3C_DEBUG 0

// Version-specific configuration.
#if defined(PRST_VERSION_1_1_X)
// The photoresistor (LDR) is optional in this revision. If set to 1, the LDR's
// ADC channel will be sampled and its data will be encoded in the BLE
// advertisement packet.
#define PRST_HAS_LDR 1

// Light sensor pins.
#define PRST_PHOTO_V_PIN NRF_GPIO_PIN_MAP(0, 29)
#define PRST_PHOTO_OUT_PIN NRF_GPIO_PIN_MAP(0, 2)

// Whether to produce debug messages for the LDR
#define PRST_ADC_PHOTO_DEBUG 1

#endif  // End of version-specific configuration.

#endif  // _PRST_CONFIG_H_